|
AMSOIL PowerSports Air
Filters save money. They are washable and reusable for hours of
trouble-free service. In addition, PowerSports Air Filters have greater
life expectancy than competitive air filters.
PRODUCT DESCRIPTION
AMSOIL PowerSports 2-Stage Air Filters provide superior performance in
all three critical areas of filtration:
Efficiency (dirt-stopping),
Capacity (dirt-holding) and Resistance (air flow).
AMSOIL PowerSports 2-Stage Air Filters
are uniquely designed to hold wear-causing dirt while allowing only
clean air for better performance, better fuel economy, lower exhaust
emissions and longer engine life. Also, AMSOIL PowerSports 2-Stage Air
Filters are washable and reusable for numerous hours of trouble-free
service.
AMSOIL PowerSports 2-Stage Air Filters
are especially designed for PowerSports such as ATV’s and Dirt Bikes.
The filters feature two distinct layers of oil-wetted polyurethane foam,
which provides a network of interlocking cells that trap particles
primarily on the surface, yet allow a constant flow of clean intake air
for outstanding engine protection and performance.
AMSOIL PowerSports 2-Stage Air Filters
are constructed of polyurethane foam and the 2-stage foam’s thickness
allows for even more filtering area and capacity to trap dirt over a
longer period of time.
POWERSPORTS FILTER CLEANING AND OILING
PROCEDURES
The AMSOIL PowerSports 2 Stage Air Filter is constructed with the
highest quality foam filter media available. This filter, when used in
combination with AMSOIL Foam Filter Oil (AFO),
will maximize engine performance and provide the most effective
filtration available for your engine.
NOTE: OIL BEFORE USE! AMSOIL
PowerSports 2 Stage Air Filters are packaged dry. Proper filter oiling
before use is necessary to prevent dirt from entering the air intake
system. AMSOIL recommends using AMSOIL Foam Filter Oil
(AFO). AFO is properly designed with high quality tacking agents
that stick to dirt. AMSOIL Foam Filter Oil (AFO) is available in 8 oz.
containers and can be purchased through your AMSOIL Dealer.
Follow the instructions below to
properly prepare your filter for use.
Your local conditions and intended use
will determine how often your air filter should be inspected and
cleaned. Frequent cleaning and oiling is necessary for best performance
and protection against engine wear.
Filter cleaning:
1) Carefully remove the air filter
being cautious not to knock any dust or dirt into the carburetor
opening. Clean any dirt from the opening with a clean shop towel.
2) Clean filter in a solution of warm
water and mild detergent. Do not use strong solvents, gasoline, or
other fuels to clean the filter.
3) After washing, thoroughly rinse
the filter with clean water and allow it to air dry. Note: Do not
use high-pressure shop air or heat to dry the filter. After the
filter is completely dry it can be re-oiled for further use.
Applying filter oil:
For best performance, use a generous
amount of filter oil and work it into foam media. Squeeze out excess
oil, leaving a uniformly oiled filter.
A properly oiled filter will feel
oily or tacky to the touch on both the outer and inner surfaces, but
should not be dripping filter oil.
When reinstalling the filter use a thin
film of Multi-Purpose Grease on the foam base to insure a leak free seal
between the filter and the housing. |